Return To Horizontal Gallery   

Robert Best,          Kans City, MO        4/20/2007

1/3 scale Mogul 1 HP

I just finish two of these engine. All the painted parts I cast from aluminum and then a iron sleeve was pressed in. The brass parts were milled or fabricated.  The throttle is a cylinder in place of a butterfly.  Its 1/3 scale with six inch flywheels and a bore of 1-1/8 and one inch stroke. Runs well.


4/4/2010 The model of the 1/3 scale Mogul that I had you put on the web can now be seen on you tube running. 



Copyright 2007,  Florida Association of Model Engineers and engine builder as noted above, All rights reserved.