Return To Horizontal Gallery
Don Chadwick, DChadwick@synergy.gs 3/20/2011
Bore - 1.250
Stroke - 1.625
Flywheel – 6 ¾” Diameter
This is my first IC engine. It was purchased from Michael Pershinsky in PA. I started on this engine in October of 2010 and finished it March 4, 2011. It has a built up crankshaft and homemade spark plug. Many other parts that were not included in the casting kit were fabricated. All of the Brass components were bead blasted for a satin look. I also use a micro switch and buzz coil for ignition.
Copyright 2011, Florida Association of Model Engineers and engine builder as noted above, All rights reserved.